Cost Is Shown
Every component line on your quote shows what it costs us. You are paying for measurement and assembly, not for a percentage on a shaft.
Rates
What It Costs, Written Out Before You Book
Session fees are for our time and the measurement work. Components are charged at what they cost plus a flat build labour figure — there is no percentage markup hidden in the part.
Session fees
Bench Time
Every session fee below credits in full against any build we complete for you within sixty days of the appointment.
Single Club Audit
$45 30 minutes- One club fully measured and plotted
- Weight, swingweight, balance point
- Length, loft, lie recorded
- Printed audit sheet to keep
Most booked
Putter Bench
$110 60 minutes- Stroke arc capture, twenty strokes
- Eye line and length measurement
- Head mass matched to green speed
- Counterweight testing included
- Roll quality filmed on the mat
Driver or Fairway Wood
$135 75 minutes- Current club audited first
- Adjustable test builds, 2 g steps
- Face tape strike mapping
- Launch and spin capture
- Written mass plan
Wedge Session
$115 60 minutes, up to three wedges- Divot pattern and sole contact reading
- Bounce and grind selection
- Gapping plotted from your set
- Groove and ferrule condition check
Iron Set Build
$185 90 minutes- Whole existing set audited and plotted
- Lie board and impact tape session
- Shaft weight class testing
- Head sorting by measured mass
- Full progression table written out
Full Bag Audit
$330 Two visits- All fourteen clubs measured and plotted
- Gapping analysis across the bag
- Bench time on each problem club
- Complete ledger set produced
- Written priority list of what to fix first
Bench labour
Build and Repair Work
Components are additional and charged at cost. These figures are labour only.
| Work | Labour | Notes |
|---|---|---|
| Regrip, per club | $7 | Tape included, count recorded on card |
| Regrip, full set of 13 | $78 | All grips weighed and matched |
| Reshaft, wood with adapter | $35 | Includes adapter pull and torque log |
| Reshaft, iron or wedge | $28 | Includes ferrule and tip prep |
| Loft and lie, per club | $9 | Measured, bent, re-measured |
| Loft and lie, full set | $85 | Set plotted before and after |
| Swingweight rebalance | $14 | Tip or butt weight, per club |
| Counterweight install | $22 | Weight, cap and balance point re-measure |
| Ferrule replacement | $16 | Turned flush, per club |
| Full set assembly labour | $140 | Sorting, building, cure and ledger cards |
| Ledger card reprint | Free | Any time, any club we have built |
How components are priced
No Markup Hiding in the Part
Bring Your Own Parts
Supplying your own shaft or grip is fine and reduces the bill by exactly what the part would have cost. Labour is unchanged.
Rework Is Ours
A club that reads outside our published tolerance gets rebuilt at our expense. That is what publishing a band means.
Payment and cancellation
Session fees are taken at the appointment, not in advance. Cancel or move a booking with at least
twelve hours' notice and there is no charge. Repeat no-shows get asked for a deposit before the
next booking, which we would rather never do.
Booking
Start With the Cheapest Thing on the List
A forty-five dollar single club audit answers more questions than most people expect, and it credits back if you go on to build. There is no reason to start bigger.