Jump to page content
Memphis, Tennessee · Bench open since 2011 Sat 8:00 AM – 4:00 PM · Sunday reserved for component intake [email protected]
Putter Lab Golf Club Building & Mass Fitting
Bench Journal

Notes Written Between Builds

Mostly by Naomi, occasionally by Ravi when a ferrule has annoyed him. Written because the same questions come up at the counter every week and deserve a proper answer.

Static Weight and Swingweight Are Two Different Arguments

The scale and the swingweight gauge answer completely different questions, and confusing them is the single most common reason a club that "should" fit does not.

Read the note

Reading a Balance Point Off the Ledger

Why we record the distance from the butt cap to the balance position on every card, and what that one number tells you that swingweight cannot.

Read the note

The Gap Behind a Ferrule, and What Gets Into It

How to check your own ferrules with a thumbnail, why wedges fail first, and what a hairline gap turns into after two Memphis summers.

Read the note

Turned Ferrules and Pre-Bored Ferrules Do Not Fail the Same Way

Two ways of getting a ferrule flush against a hosel, two very different failure modes, and why we still turn most of ours on the bench.

Read the note

How Many Wraps of Tape Your Hands Actually Want

Tape wraps are a size adjustment and a mass adjustment at the same time. Here is how we decide the count, and why it goes on the ledger card.

Read the note

Solvent, Cure Time, and Why We Weigh a Grip Twice

A freshly installed grip is heavier than the same grip a day later. If your shop measures swingweight straight after a regrip, they are measuring solvent.

Read the note
From reading to measuring

Your Own Numbers Are More Interesting Than Ours

Every article here describes something we can measure on your clubs in under an hour. Book the single club audit and watch it happen rather than taking our word for it.